How to change a D-Link router to AP mode | Visual.ly

Connect a computer to the D-link router and launch a web browser.

Visit the following router configuration page: http://192.168.0.1.

You are prompted to enter a username and password.

Click Setup > Local Network.

Set the DHCP Mode to Off.

Click Apply Changes.


https://visual.ly/community/Others/computers/how-change-d-link-router-ap-mode 


#Dlinkap.local #http://dlinkap.local #Dlink Extender Login

Comments

Post a Comment

Popular posts from this blog

Points to keep in mind while updating D-link Extender Software/Firmware | Imgbb

 Make sure your D-link Extender is powered ON, during the Firmware up-gradation process. Do not press the Power button on the D-link extender while the software is getting updated. If you are not able to access the D-link Extender web management page via http://dlinkap.local, make sure that your device is connected with the D-link extender wired or wirelessly. Alternatively, Users can use the IP address 192.168.0.50. https://ibb.co/wB16Sg4 #Dlinkap.local #http://dlinkap.local #Dlink Extender Login
Read more

TROUBLESHOOT DLINK DAP-1860 ISSUES | Dlinkap.local

Unable to connect to the router: TO resolve this issue, make sure your extender is within the range of your wireless router. Where to place DAP-1860 extender: The placement of the extender really matters to get good Wi-Fi signal and speed. Use the signal strength indicator to make sure you are getting max signal. Forgot the admin password to open the web interface: To handle this situation, only solution is reset your extender to factory default settings. https://dlink19966160.wordpress.com/2022/01/21/troubleshoot-dlink-dap-1860-issues/   #Dlinkap.local #http://dlinkap.local #Dlink Extender Login
Read more